5 easy ways to remove burn marks from your iron

Is your iron looking worse for wear, marred by unsightly burn marks that threaten to ruin your favourite outfits? Don’t worry—you don’t need to replace it just yet! With a few clever household tricks, you can restore your iron’s soleplate to its former glory in no time.

Here are five easy and surprisingly satisfying ways to remove those stubborn scorch marks and keep your iron in tip-top shape.

1. Baking Soda Paste: The Trusted Classic

Burn marks don’t stand a chance against the magic of baking soda.

• What to Do: Mix two tablespoons of baking soda with a splash of water to create a thick paste. Apply it to the burnt areas, then scrub gently with a soft cloth or sponge. Wipe it clean with a damp cloth and dry the soleplate.

• Why It Works: Baking soda’s mild abrasiveness lifts away stains without scratching the surface.

2. White Vinegar: The All-Purpose Hero

White vinegar isn’t just for salads—it’s also a cleaning powerhouse.

• What to Do: Heat some vinegar (just warm, not boiling) and soak a clean cloth in it. Use the damp cloth to rub the burnt spots on the iron. For tougher stains, leave the vinegar-soaked cloth on the affected area for a few minutes before scrubbing.

• Why It Works: The acidity of vinegar dissolves grime and residue effortlessly.

3. Salt Scrub: Old-School and Effective

Who knew that common table salt could save your iron?

• What to Do: Sprinkle a generous amount of salt onto a sheet of newspaper or brown paper. Set the iron to low or medium heat (without steam), then run it over the salt in circular motions. Watch as the burn marks disappear!

• Why It Works: The rough texture of salt scrapes off burnt residue without damaging the iron’s surface.

 

4. Toothpaste Trick: Your Iron’s Fresh Start

That tube of toothpaste in your bathroom isn’t just for your teeth.

• What to Do: Spread a small amount of non-gel toothpaste onto the burnt areas of the soleplate. Gently rub it in with a damp cloth using circular motions, then wipe clean with another cloth. Dry the iron thoroughly before using it.

• Why It Works: Toothpaste is slightly abrasive, making it perfect for polishing away tough marks.

5. Hydrogen Peroxide: Science Meets Cleaning

When all else fails, let hydrogen peroxide work its magic.

• What to Do: Soak a clean towel in hydrogen peroxide and lay it flat. Set your iron to a low temperature, then press the iron onto the towel. Let the heat and peroxide loosen the burn marks. Repeat until your iron is spotless.

• Why It Works: Hydrogen peroxide breaks down residues effectively, especially when combined with heat.

Keep Your Iron Clean: Bonus Tips

• Prevention is key: Always check fabric labels to use the right heat setting.

• Clean regularly: Wipe down your iron’s soleplate after use to prevent build-up.

• Avoid harsh tools: Stay away from metal scrapers that can damage the surface.

Say goodbye to frustrating burn marks and hello to flawless ironing sessions. With these simple hacks, your iron will look as good as new—and your clothes will thank you for it!

Read Full Story